| ausmini https://www.ausmini.com/forums/ |
|
| Alternator problem https://www.ausmini.com/forums/viewtopic.php?f=2&t=20241 |
Page 1 of 1 |
| Author: | The Toolman [ Sat Jun 17, 2006 1:09 pm ] |
| Post subject: | Alternator problem |
I've just fitted a Bosch Alternator from a N13 Pulsar, and have it wired up as per instructions, but the problem is it doesn't seem to be charging. I wasn't able to get it tested from where I got it from, but it is under warranty When I put the voltmeter across the B+ termianl with the wire disconnected from the solenoid, I only get a reading of .7V and goes up to 1.5 when I rev it, Would a new regulator fix this? Cheers |
|
| Author: | 9YaTaH [ Thu Jun 22, 2006 10:35 pm ] |
| Post subject: | undo some wires |
Take off the wires where it feeds the loom....and see what the voltage reads then....you may have a short somewhere. Double check the way you have wired it. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|