| ausmini https://www.ausmini.com/forums/ |
|
| intake manifold question https://www.ausmini.com/forums/viewtopic.php?f=2&t=20523 |
Page 1 of 1 |
| Author: | marcello [ Sun Jun 25, 2006 7:43 pm ] |
| Post subject: | intake manifold question |
i have just been given a set of extractors and a bigger exhaust pipe for my moke. i also have an intake that has been cut off a stock manifold. could i use this to run my 1100 or would it ice up as it no longer has a the exhaust heat keeping it warm. if i can use it, is there anything i can do to make it even better? the carb is 1 1/2. su |
|
| Author: | Mike_Byron [ Sun Jun 25, 2006 8:13 pm ] |
| Post subject: | |
Short answer is yes Its a common modification. A fair bit of heat comes from there once the engine warms. In all but the severest of frosts, you wont have icing. I would be more worried about iced toes and fingers in a moke than an iced carby *s*. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|