| ausmini https://www.ausmini.com/forums/ |
|
| brakes bleeding https://www.ausmini.com/forums/viewtopic.php?f=2&t=20733 |
Page 1 of 1 |
| Author: | aussie [ Sun Jul 02, 2006 1:43 pm ] |
| Post subject: | brakes bleeding |
possibly stupid question but why arent there brake bleader valves on the front brakes? Or are there and I just can't find them..or do you just bleed them from the back? thanks |
|
| Author: | 9YaTaH [ Sun Jul 02, 2006 2:05 pm ] |
| Post subject: | Re: brakes bleeding |
aussie wrote: possibly stupid question but why arent there brake bleader valves on the front brakes? Or are there and I just can't find them..or do you just bleed them from the back?
thanks Disks or Drums 
Assuming drums....go out and have another look...say passengers side, to the right of the drum at the back....you will see a pipe coming in and the bleeder is above that pointing up at an angle. |
|
| Author: | aussie [ Sun Jul 02, 2006 2:08 pm ] |
| Post subject: | |
yes drums... cheers for that 9YaTaH |
|
| Author: | mooman10_0 [ Sun Jul 02, 2006 2:23 pm ] |
| Post subject: | |
Start back passenger side (furthest away from master) and work your way towards the master cylinder, for best results. |
|
| Author: | aussie [ Sun Jul 02, 2006 4:56 pm ] |
| Post subject: | |
turned out there was a leak in one of the pipes so that needs to be replaced before the brakes will work 
|
|
| Author: | 9YaTaH [ Sun Jul 02, 2006 5:14 pm ] |
| Post subject: | Lines |
aussie wrote: turned out there was a leak in one of the pipes so that needs to be replaced before the brakes will work
If the pipe is rusted through...then replace the lot....the chances are they will all be in the same condition....take yours as samples to a brake place and they will make them up for you 
|
|
| Author: | aussie [ Sun Jul 02, 2006 5:18 pm ] |
| Post subject: | Re: Lines |
9YaTaH wrote: aussie wrote: turned out there was a leak in one of the pipes so that needs to be replaced before the brakes will work If the pipe is rusted through...then replace the lot....the chances are they will all be in the same condition....take yours as samples to a brake place and they will make them up for you they arent actuall too bad..it was just the connection of one of the hoses - the bolt was slightly threaded and there was fluid leaking from there. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|