ausmini
https://www.ausmini.com/forums/

Tie Rods - repair tip
https://www.ausmini.com/forums/viewtopic.php?f=2&t=2123		 Page 1 of 1
Author:  J_A_M [ Thu Sep 30, 2004 9:50 pm ]
Post subject:  Tie Rods - repair tip
In the past I thought if the rubber boot on a tie rod was fooked, you replaced the whole thing.

The other day I bought 2 new rubber boots only for my tie rods (couple of dollars each) and stripped / repaired them both.

So now I have two AS NEW tie rods for a measley few dollars.

Not a bad tip I reckon. :wink:
Author:  drmini in aust [ Thu Sep 30, 2004 9:53 pm ]
Post subject: 
Hope you stuck some grease in there, too.. :wink:

I bought a `grease needle' a while back, very handy for greasing old tie rod ends and knuckle joints, in situ.. 8)
Author:  J_A_M [ Thu Sep 30, 2004 10:02 pm ]
Post subject: 
is there supposed to be grease in them....... :shock:

:lol: Yea, I packed them to the hilt!
Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/