On 1100 and 998 Hastings rings, the 7 sided thing is a spring. It goes in first. DON'T LEAVE IT OUT.
Then the centre piece goes in.
Then the 2 oil scraper rings go each side of that.
Should be instructions in the box....
| ausmini https://www.ausmini.com/forums/ |
|
| hastings rings on hypatecs https://www.ausmini.com/forums/viewtopic.php?f=2&t=21372 |
Page 1 of 1 |
| Author: | benjamin [ Fri Aug 11, 2006 6:39 pm ] |
| Post subject: | hastings rings on hypatecs |
with the oil groove there seems to be 4 peices, two rings the std oil thing that goes between them and this 7 sided thingo ? the seven sided thingo iv neve seen befor help how does it go together, ill upload a pic if it dont make any sence |
|
| Author: | drmini in aust [ Fri Aug 11, 2006 7:10 pm ] |
| Post subject: | |
On 1100 and 998 Hastings rings, the 7 sided thing is a spring. It goes in first. DON'T LEAVE IT OUT. Then the centre piece goes in. Then the 2 oil scraper rings go each side of that.
Should be instructions in the box.... |
|
| Author: | benjamin [ Fri Aug 11, 2006 7:15 pm ] |
| Post subject: | |
thanks kev , i thought thats how it went beut it just looked wrong, the instructions are terrible 
|
|
| Author: | drmini in aust [ Fri Aug 11, 2006 7:19 pm ] |
| Post subject: | |
It's hard to get the oil rings wrong, but watch which way up the compression rings go. Read the instructions... then check the rings, carefully. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|