GT wrote:
I have a spare roof lining with rods. Might sell it, if you desperately need one.
I will have a look, if can't find any I will pm you
| ausmini https://www.ausmini.com/forums/ |
|
| Wanted Specifications of headlining rods for roof linning... https://www.ausmini.com/forums/viewtopic.php?f=2&t=21916 |
Page 1 of 1 |
| Author: | YoungMiniac [ Sun Aug 27, 2006 6:21 pm ] |
| Post subject: | Wanted Specifications of headlining rods for roof linning... |
I don't have any roof lining ro roof lining roods and I know they are hard to get, so I was wondering if anyone knows the specifations, angles size of round bar and legnth... All help appreciated.. Thanks Ian |
|
| Author: | Mike_Byron [ Sun Aug 27, 2006 6:26 pm ] |
| Post subject: | |
Just go to a wrecking yard and grab them out on one of their minis - they are the same for all minis regardless of year. Just be aware that to replace headling means pulling out the front and rear windscreens - that mostly means new rubbers and locking strips and a further complicaition. Laminated windscreens (if you have one) become very brittle over time and dont happily survive a refit. |
|
| Author: | YoungMiniac [ Sun Aug 27, 2006 6:31 pm ] |
| Post subject: | |
I have no roof linning.... Can't find any minis at wreckers round here...... |
|
| Author: | GT [ Sun Aug 27, 2006 6:59 pm ] |
| Post subject: | |
I doubt very much that someone could accurately describe the bars for Mini rooflining. I was looking at my GT roof lining today. I even thing the bars are not all the same. Anyone? You will HAVE to buy a second hand roof lining with the bars. They are out there. I have a spare roof lining with rods. Might sell it, if you desperately need one. |
|
| Author: | YoungMiniac [ Sun Aug 27, 2006 7:14 pm ] |
| Post subject: | |
GT wrote: I have a spare roof lining with rods. Might sell it, if you desperately need one.
I will have a look, if can't find any I will pm you
|
|
| Author: | Mike_Byron [ Sun Aug 27, 2006 7:46 pm ] |
| Post subject: | |
Geez Ian - I have taken several sets of bars to the tip. Mate, its really not worth making up your own although you only need one and you can copy it and bend up your own. maybe somebody in the west has a mini under resto that would let you have a lend of one for a copy. Its nothiong special - quarter is steel rod bowed in the middle with a bend at each end. |
|
| Author: | YoungMiniac [ Sun Aug 27, 2006 7:49 pm ] |
| Post subject: | |
Easy to make... I guess I just need some nice person in W.A to lend me one 
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|