| ausmini https://www.ausmini.com/forums/ |
|
| Engine number https://www.ausmini.com/forums/viewtopic.php?f=2&t=22010 |
Page 1 of 1 |
| Author: | Blokeinamoke [ Wed Aug 30, 2006 8:43 am ] |
| Post subject: | Engine number |
I cant find the engine number on the Mokes engine. I have looked all over and cant find it. Any suggestions? |
|
| Author: | Rodney [ Wed Aug 30, 2006 9:04 am ] |
| Post subject: | |
Should be in the same place as the Mini I would have thought - stamped on the block near #1 cylinder. Has your block been decked???? Maybe the engine number has been shaved off in the process. Hooroo |
|
| Author: | Blokeinamoke [ Wed Aug 30, 2006 9:05 am ] |
| Post subject: | |
Dont know if its been decked, but I will look near 1 and 4 in case I have cylinder numbers wrong. |
|
| Author: | sports850 [ Wed Aug 30, 2006 9:13 am ] |
| Post subject: | |
CLean off whatever paint etc is there with some sandpaper or emery cloth on a flat board (swipe your wife's nail file ....) gently and if there's any indentation left it will gradually show up by the very thin layer of paint trapped in them . Just make sure you sand/file it gently and the board is flat . It'll be easier to do with the head off but still possible with the head on . |
|
| Author: | gafmo [ Wed Aug 30, 2006 7:19 pm ] |
| Post subject: | |
Radiator end near the Temp Sender location |
|
| Author: | Blokeinamoke [ Thu Aug 31, 2006 7:36 am ] |
| Post subject: | |
Found it thanks. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|