ausmini
https://www.ausmini.com/forums/

please help
https://www.ausmini.com/forums/viewtopic.php?f=2&t=22139
Page 1 of 1

Author:  mini-dunger [ Sat Sep 02, 2006 7:47 pm ]
Post subject:  please help

Hi guys I am putting new upper and lower ball joints in my mini and the keep binding up on the seat. I have the 3 shims plus the locking plate but once the big nut is tightened it binds up. Do you think I should use some of the old bushes as well or is something else wrong?

Author:  mini-dunger [ Sat Sep 02, 2006 7:50 pm ]
Post subject:  i think i found the answer

I never have much luck with this search engine but i tried it and I came up with this. http://www.ausmini.com/forums/viewtopic ... all+joints I think i just gotta clean the grease off then tighten it up then adjust the shims to suit then grease.
thanks anyways

Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/