hey guys would someone be able to tell me if door higes are the same for top and bottom?
does it matter which one goes on top or which one goes on bottom..and how do you tell
cheers
| ausmini https://www.ausmini.com/forums/ |
|
| quick question - help please https://www.ausmini.com/forums/viewtopic.php?f=2&t=22512 |
Page 1 of 1 |
| Author: | aussie [ Wed Sep 13, 2006 4:44 pm ] |
| Post subject: | quick question - help please |
hey guys would someone be able to tell me if door higes are the same for top and bottom? does it matter which one goes on top or which one goes on bottom..and how do you tell
cheers |
|
| Author: | Zizzle [ Wed Sep 13, 2006 4:47 pm ] |
| Post subject: | |
Yes it does matter. It is stamped in them. Look for LL, LU, RU, RL from memory. |
|
| Author: | czerial [ Wed Sep 13, 2006 4:54 pm ] |
| Post subject: | |
yup and just incase ur a little dense, LU is left upper LL is Left lower RU is Right Upper RL is Right Lower |
|
| Author: | cush [ Wed Sep 13, 2006 4:59 pm ] |
| Post subject: | |
yes... it matters and in case you didn't read the last two posts RU = Right Upper RL = Right Lower LU = left upper LL = Left lower 
and guessing by your sig pic, you seem to have attached your doors already 
|
|
| Author: | aussie [ Wed Sep 13, 2006 5:07 pm ] |
| Post subject: | |
no wonder the doors didnt want to go on properly
Some FIdiot put a LU and a RU on the Right side   
|
|
| Author: | aussie [ Wed Sep 13, 2006 5:08 pm ] |
| Post subject: | |
cush wrote: and guessing by your sig pic, you seem to have attached your doors already
yep, but as you can see in the sig pic the door isn't shutting properly and on an angle 
|
|
| Author: | czerial [ Wed Sep 13, 2006 5:11 pm ] |
| Post subject: | |
i thort the door was open on purpose! did u spray the car with the doors on, or are u the goose that did it:? 
|
|
| Author: | aussie [ Wed Sep 13, 2006 6:07 pm ] |
| Post subject: | |
the car was sprayed with the hinges on. there were hinges on the shell when i got it, i just assumed they were the right ones. |
|
| Author: | Spaceboy [ Thu Sep 14, 2006 11:43 pm ] |
| Post subject: | |
to assume makes an ass out of u and me |
|
| Author: | cush [ Fri Sep 15, 2006 9:07 am ] |
| Post subject: | |
bugger, ey? got any paint left? |
|
| Author: | aussie [ Fri Sep 15, 2006 9:49 am ] |
| Post subject: | |
yea lucky we saved some
Gotta bribe the neighbour with beer to come over and spray the hinges now |
|
| Author: | gibovski [ Fri Sep 15, 2006 10:16 am ] |
| Post subject: | |
I have a drivers door that doesn't quite line up with the body at the bottom. Sits a bit out from the body. The door closes properly though. Could that be an incorrect hinge? Where does one find these markings on the hinges? |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|