Its a power brake bleeder using an air compressor. They linked up nylon hose to the vacuum end end of a sand sand blaster and voila instant vacuum brake bleader
| ausmini https://www.ausmini.com/forums/ |
|
| Cool Idea - Power Bleeder https://www.ausmini.com/forums/viewtopic.php?f=2&t=22618 |
Page 1 of 1 |
| Author: | Blokeinamoke [ Sat Sep 16, 2006 7:37 pm ] |
| Post subject: | Cool Idea - Power Bleeder |
Its a power brake bleeder using an air compressor. They linked up nylon hose to the vacuum end end of a sand sand blaster and voila instant vacuum brake bleader
|
|
| Author: | Gadgets mini [ Sat Sep 16, 2006 9:48 pm ] |
| Post subject: | |
i want one 
|
|
| Author: | hutto [ Sat Sep 16, 2006 10:24 pm ] |
| Post subject: | |
oh yeah good idea.. so where do we buy one of these? 
|
|
| Author: | Blokeinamoke [ Sun Sep 17, 2006 8:11 am ] |
| Post subject: | |
Gadgets mini wrote: 8)
i want one Just make it thats the whole idea 
|
|
| Author: | Stuartminidlx [ Sun Sep 17, 2006 1:05 pm ] |
| Post subject: | |
most places sell them for around 100 bucks or so your need to be careful if your system is abit old though |
|
| Author: | DOZ [ Sun Sep 17, 2006 4:03 pm ] |
| Post subject: | |
I like the idea but I use the compressor to slightly pressurise the master cyl. res. instead. What I do is fill with fluid and replace cap only (not diaphragm) then open bleed nipple to be bled. I use the air duster (blower) and slowly introduce pressure to master cyl, the best way is to blow away from the little hole on top then slowly go closer (if that makes sense). I watch the fluid go down and when it's getting low i stop and close bleeder, move onto next one and repeat. It doesn't take long. Be careful though, If you just pressurise M/C too much then it will blow apart. Either way would have it's pros/cons and I think the end result would be the same amount of time and equally air-free system. DOZ |
|
| Author: | Blokeinamoke [ Sun Sep 17, 2006 4:38 pm ] |
| Post subject: | |
Stuartminidlx wrote: most places sell them for around 100 bucks or so your need to be careful if your system is abit old though
For the love of god!!! The entire purpose of this thread was to show you a way make one without spending the $100.. |
|
| Author: | badassmini [ Sun Sep 17, 2006 4:56 pm ] |
| Post subject: | |
i like it good idea |
|
| Author: | Gadgets mini [ Sun Sep 17, 2006 5:15 pm ] |
| Post subject: | |
Blokeinamoke wrote: For the love of god!!! The entire purpose of this thread was to show you a way make one without spending the $100.. ROFL Keep Calm there BIAM dont let that bloodpresure get too high 
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|