ausmini
https://www.ausmini.com/forums/

More rust removal - bottom of quarter panels
https://www.ausmini.com/forums/viewtopic.php?f=2&t=23005		 Page 1 of 1
Author:  britishvita [ Wed Sep 27, 2006 7:32 pm ]
Post subject:  More rust removal - bottom of quarter panels
Alrighty next up for removal is a bit more "character" (rust) in the lower and rear quarter panels (pic's below).

So should i try and get a donor section off another car or just put a patch of sheet in there - my biggest hesitasion is the little lip that the chrome goes onto.

What have other people done ??

Image

Image
Author:  mini-dunger [ Wed Sep 27, 2006 11:43 pm ]
Post subject:  rust repair
i used a small patch on one side. Just migged it in real slow, I hit the welds with compressed air in between bursts to cool it down to keep warpage to a minimum. The other side that was not quite so bad so I just wired wheeled the rust off, treated it with rust converter and filled in the holes with the mig. Nice and slow as per other side.
:o
Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/