ausmini
https://www.ausmini.com/forums/

Wiper Wheel contacts - Made my own!
https://www.ausmini.com/forums/viewtopic.php?f=2&t=23231		 Page 1 of 1
Author:  pristic [ Wed Oct 04, 2006 9:10 am ]
Post subject:  Wiper Wheel contacts - Made my own!
Howdy,

So, I have pulled apart the wiper motor to clean old grease and put new grease in, etc...
The wheel inside (2 speed) has a hole worn through the contact.

No sweat, ill get a new one to replace it... :shock:
No one has any!

Where do you find them? Should I just whack the old one in (it was working) dont know if it'll work anymore :lol:

Peter.
Author:  ELMO [ Thu Oct 05, 2006 12:42 am ]
Post subject: 
If you mean the steel face to the gear, Mini Spares Center has after market laser cut stainless steel plates for replacement. The first one I got was not cut concentrically. They were suprised when I showed them and they gladly gave me another one. No more corroding contact areas. 80 Gibson Avenue, Padstow. 97743366.
Author:  drmini in aust [ Thu Oct 05, 2006 6:39 am ]
Post subject: 
Convertible Mini on here had some made too. Maybe cheaper, PM him. :wink:
Author:  PetenSoaf [ Thu Oct 05, 2006 8:55 am ]
Post subject: 
Or just do what Al from MiniCentral over here in Perth does. . .get yourself a bit of thin metal sheet. . .steel , brass whatever you like. . .and cut your own out with nail scissors.
Author:  pristic [ Mon Oct 09, 2006 5:51 pm ]
Post subject: 
Sorry guys,

Been away for a bit.
Ill try making my own, if that fails ill call around :)

Peter.
Author:  pristic [ Fri Oct 13, 2006 9:35 am ]
Post subject: 
Sweet, I made my own :)
I got a Dremel kit for Fathers Day and used it with a carbide tungsten tip.

No sheet metal, copper or anything around so I went inside to make myself a cup of Milo... AHA!!!! The Milo lid looked good.

Grabbed the lid, marked it and now I have a nice new shiny contact for the cog.

Pics to follow :)

Peter.
Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/