how hard is it to get the bottom hose on to the water pump. As I had unbelieveable trouble
| ausmini https://www.ausmini.com/forums/ |
|
| Bottom radiator hose https://www.ausmini.com/forums/viewtopic.php?f=2&t=23600 |
Page 1 of 1 |
| Author: | steamer [ Thu Oct 12, 2006 8:41 pm ] |
| Post subject: | Bottom radiator hose |
how hard is it to get the bottom hose on to the water pump. As I had unbelieveable trouble
|
|
| Author: | gafmo [ Thu Oct 12, 2006 8:49 pm ] |
| Post subject: | |
Bottom Rad hose dos not go onto the water pump...but anyway yes its a sod of a job...mainly due to people putting the hose clips on in a impossible possition to undo ...otherwise a nice big long screwdrive is the very handy and a long arm ready for some bloody also helps |
|
| Author: | steamer [ Thu Oct 12, 2006 8:58 pm ] |
| Post subject: | |
it goes from the engine to the bottom of the radiator It was an utter ning nong to get on to the barb hence I had to make up an adaptor. The hose clamps were easy to get off you need a socket about 7mm or 5/16 
|
|
| Author: | smac [ Thu Oct 12, 2006 9:27 pm ] |
| Post subject: | |
I'm sorry, but in what way does the bottom hose not go to the water pump??! |
|
| Author: | Hanra [ Thu Oct 12, 2006 9:29 pm ] |
| Post subject: | |
Exactly? Of course it does......! |
|
| Author: | gafmo [ Thu Oct 12, 2006 9:36 pm ] |
| Post subject: | |
yer you are rite..its been a long time since I took a pump off...My Bad |
|
| Author: | meeni [ Thu Oct 12, 2006 9:50 pm ] |
| Post subject: | |
its not that hard if your put it on the pump side first, then modify the rad cowling so that you can put the clip on the bottom tank in the rad |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|