| ausmini https://www.ausmini.com/forums/ |
|
| Ignition problems help!!!! https://www.ausmini.com/forums/viewtopic.php?f=2&t=23637 |
Page 1 of 1 |
| Author: | dr gonzo [ Fri Oct 13, 2006 5:57 pm ] |
| Post subject: | Ignition problems help!!!! |
I am taking my morris 850 to get a new waterpump tommorow and went outside to start it(as I do afternoons) it started fine but then began to lose revs and then stopped. It the started again fine but same problem. Also when I push the accelrator pedal NOTHING no revs, just says running at the same low rev, I could actuallt press the whole pedal in and it still would stay the same. I haven't taken it for a run for a week and a half but I really need to know what this problem may be as I have to get it to the mechanics tomorrow. Please help guys and girls. |
|
| Author: | dr gonzo [ Fri Oct 13, 2006 10:52 pm ] |
| Post subject: | |
thanks all??? |
|
| Author: | speedy [ Fri Oct 13, 2006 10:54 pm ] |
| Post subject: | |
Have you check its getting enough fuel? |
|
| Author: | dr gonzo [ Fri Oct 13, 2006 10:57 pm ] |
| Post subject: | |
might sound silly, but how would I check that? |
|
| Author: | drmini in aust [ Sat Oct 14, 2006 6:06 am ] |
| Post subject: | |
Can you hear the fuel pump tick at all when you turn the ignition on... If not it may need a swift kick like mine used to. 
Undo the lid of the float bowl, see it there's petrol in there. While it's off, put a tin under it, then get someone to turn ignition on for a few secs. 
|
|
| Author: | Mike_Byron [ Sat Oct 14, 2006 10:10 am ] |
| Post subject: | |
Throttle cable loose and slipping ????? Or broken ????? Does it rev if you turn the throttle bit on the carby itself. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|