| ausmini https://www.ausmini.com/forums/ |
|
| Tie rods https://www.ausmini.com/forums/viewtopic.php?f=2&t=24319 |
Page 1 of 1 |
| Author: | Wombat [ Wed Nov 01, 2006 1:35 pm ] |
| Post subject: | Tie rods |
I've noticed I have one bent tie rod. Looks like someone has used it as a jack point then later turned it over as the V is down Anyway it is about 1/4" out of straight. Is it OK to straighten or should it be replaced? |
|
| Author: | minimalist_1 [ Wed Nov 01, 2006 3:16 pm ] |
| Post subject: | |
If its 1/4 of an inch out then it should be ok to straighten. be careful not to damage the threads and examine for cracks just incase it occured from hitting somthing. i would like to know what some of the other guys think though. |
|
| Author: | 9YaTaH [ Wed Nov 01, 2006 5:37 pm ] |
| Post subject: | Rack?? |
minimalist_1 wrote: If its 1/4 of an inch out then it should be ok to straighten. be careful not to damage the threads and examine for cracks just incase it occured from hitting somthing.
i would like to know what some of the other guys think though. I would be more concerned about that end of your rack...they could have damaged bushes etc on that end...just a thought 
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|