Ok this is probarbly a stupid question but how do I fit them on? There are existing holes from the previous mirrors that are perfect spacing for the new mirrors.
Do I have to take apart the door or something to get the screws in?
Thanks

Take off door cards, that should be enough. If it's not you may have to loosten and move window winder mechanism etc. I just drilled my holes from the outside put studs on the mirror. Reached in the door (hurt hands LOL) and tightened it up. Oh forgot to mention, it all went bad for me when I dropped a nut, got magentic pickup to retrieve nut. But got that jammed and yeah, eventually got it all out. With much lost skin on the hands....ahh the memories - moral - don't drop anything!

_________________
1964 Morris 850, 1330 Supercharged - 81.8hp atws.
1975 Leyland Mini S 1100S powered - Nice and reliable.
1977 Leyland Mini LS - Project LS-T

Thanks for that. I'll go try remove the door cards now... haven't done that before.

i and (if you do a search like i did you'll find) many other actually have their bullet mirrors held on with one screw if you just tighten up the one enough that goes into the base of the mirror (the one closest to the back of car) it is enough to hold it on. it's an annoying thing to do so make sure it is tight the first time.

_________________

Sunday Morning Mini Sprint http://www.youtube.com/watch?v=UtGuzqBQ32Q my "rendezvous"

Phew managed to get em in but when removing the old mirror, the gasket was a sticky one and it ripped the paint.
Managed to drop all the spacers in the door too... oh well.

I pnly have one also...but the one to the Front..But its tight
I tied a piece of string to one end of the spanner and the other to the 1/4 window..After dropping it twice...i wised up

_________________
Stop Licking the Dog...I Don't Care Who Started It

haha
that is very wise.
i dropped the spanner and the screw.. but lucky my little hands fit inside the door !

_________________