You can get RC40's in different sizes, yes??? I don't really know, just thought you could, like how you can get them in stainless and all...
| ausmini https://www.ausmini.com/forums/ |
|
| Is an RC40 1 3/4" ? https://www.ausmini.com/forums/viewtopic.php?f=2&t=24865 |
Page 1 of 1 |
| Author: | arpy69 [ Tue Nov 14, 2006 10:22 am ] |
| Post subject: | Is an RC40 1 3/4" ? |
I want to phone around to see if I can get a second hand flexi joint to fit and don't have the car with me to measure the exhaust. Ta Rick |
|
| Author: | Wombat [ Tue Nov 14, 2006 10:27 am ] |
| Post subject: | |
Not sure but isn't the "40" = 40mm ie about 1 1/2" I could be corrected on that though |
|
| Author: | Matt68 [ Tue Nov 14, 2006 12:37 pm ] |
| Post subject: | |
I believe the RC40 I have is 1 3/4" OD. Cheers Matt |
|
| Author: | poeee [ Tue Nov 14, 2006 12:39 pm ] |
| Post subject: | |
You can get RC40's in different sizes, yes??? I don't really know, just thought you could, like how you can get them in stainless and all...
|
|
| Author: | 1360 LS [ Tue Nov 14, 2006 12:42 pm ] |
| Post subject: | |
yeah I was under the impression that a RC 40 exhaust is a 1 3/4...... |
|
| Author: | drmini in aust [ Tue Nov 14, 2006 6:32 pm ] |
| Post subject: | |
RC40 is a model, not size- it is 1-3/4" bore, takes a 1-3/4" OD pipe (ex pipe is always measured on OD) 
|
|
| Author: | arpy69 [ Wed Nov 15, 2006 8:37 am ] |
| Post subject: | |
Thanks Doc 
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|