Try A Grade Panels in Melbourne.
None of the UK made ones have these channels.
| ausmini https://www.ausmini.com/forums/ |
|
| Clubman fron floor panels https://www.ausmini.com/forums/viewtopic.php?f=2&t=25067 |
Page 1 of 1 |
| Author: | collins [ Sun Nov 19, 2006 5:21 pm ] |
| Post subject: | Clubman fron floor panels |
Are there any early clubman floor panel reproductions out there? I have the newer replacement floor panels, but the fit isn't all that great. I can make them work, but would be interested if someone had the floor panels that have the hydrolastic chanels and remote bulge in drivers side. |
|
| Author: | drmini in aust [ Sun Nov 19, 2006 6:22 pm ] |
| Post subject: | |
Try A Grade Panels in Melbourne.
None of the UK made ones have these channels.
|
|
| Author: | collins [ Tue Nov 21, 2006 2:29 pm ] |
| Post subject: | |
Yeah, I might just cut a slot where they fit in and get a few bits of Zintex bent to size and tig em in, might be easier. Going to give it a bash on the weekend after welding in Ed's rear end. |
|
| Author: | ELMO [ Tue Nov 21, 2006 9:41 pm ] |
| Post subject: | |
I cut the l/h floor out of a clubbie at pick and pay with a battery drill and cold chisel. Left enough to trim and fit , then had it welded in . |
|
| Author: | collins [ Wed Nov 22, 2006 7:58 am ] |
| Post subject: | |
Elmo, either you drilled ALLOT of holes or you went nuts with a cold chisel, surely the panel would have been deformed with all the beatng? |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|