What is the size in mm of the shaft size of a normal mini steering coulm
cheers
| ausmini https://www.ausmini.com/forums/ |
|
| shaft size https://www.ausmini.com/forums/viewtopic.php?f=2&t=25182 |
Page 1 of 1 |
| Author: | aussie [ Wed Nov 22, 2006 8:00 pm ] |
| Post subject: | shaft size |
What is the size in mm of the shaft size of a normal mini steering coulm
cheers
|
|
| Author: | 64cooper [ Wed Nov 22, 2006 8:15 pm ] |
| Post subject: | shaft size |
Hot off the vernier, 22mm. |
|
| Author: | mad-mk1 [ Wed Nov 22, 2006 8:51 pm ] |
| Post subject: | |
that tile sounds hmm interesting! 
|
|
| Author: | aussie [ Wed Nov 22, 2006 9:50 pm ] |
| Post subject: | |
so just confirming the size is 22mm ? |
|
| Author: | aussie [ Wed Nov 22, 2006 11:06 pm ] |
| Post subject: | |
can anyone confirm it? Its just I need to know to order a Boss kit for a steering wheel |
|
| Author: | 1360 LS [ Thu Nov 23, 2006 7:25 am ] |
| Post subject: | |
mad-mk1 wrote: that tile sounds hmm interesting!
Interesting indeed and easily taken the "naughty" way hehe .... so how big is a mini shaft?? |
|
| Author: | sports850 [ Thu Nov 23, 2006 7:51 am ] |
| Post subject: | |
aussie wrote: can anyone confirm it? Its just I need to know to order a Boss kit for a steering wheel
In that case then just tell them it's for a mini , other cars have the same diameter shaft but different pitch splines . |
|
| Author: | mad-mk1 [ Thu Nov 23, 2006 8:37 am ] |
| Post subject: | |
otherwise put your wheel on a piece of paper, mark out all the lines and holes, ane fax it to minisport, and theyll look after it! 1360 ls the more u stroke it the biggerit gets |
|
| Author: | 64cooper [ Thu Nov 23, 2006 7:52 pm ] |
| Post subject: | shaft measurement |
For those with the devious bent, a vernier is an accurate measuring instument and the shaft diameter in metric terms is 22mm. |
|
| Author: | 64cooper [ Thu Nov 23, 2006 8:03 pm ] |
| Post subject: | shaft diameter |
PS. Having re-read the thread, I see that the size you are really after is the spline end so I have just measured again and it is 18mm. If a boss kit is all you need, the firm you are dealing with should have the nous to supply you with the correct one. I had no trouble in getting one from autobarn. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|