| ausmini https://www.ausmini.com/forums/ |
|
| Stupid question https://www.ausmini.com/forums/viewtopic.php?f=2&t=25469 |
Page 1 of 1 |
| Author: | MIN.78S aka "higgin [ Fri Dec 01, 2006 10:03 am ] |
| Post subject: | Stupid question |
is there a difference between the thickness of tyres put on 12's and 13's...... and if so does the 12' and 13's end up being the same size in total Diameter ?? |
|
| Author: | cush [ Fri Dec 01, 2006 10:20 am ] |
| Post subject: | |
the profile will be different...lower for the 13s...(assuming thickness means profile) but the outside diameter will be nearly the same if not the same... |
|
| Author: | 1360 LS [ Fri Dec 01, 2006 10:23 am ] |
| Post subject: | |
whether it's 12" or 13" the thickness depends on the width of the rim again whether it be 5 5.5 6 7" 's wide. with a higher width number you will need to cut and lip/flare the guards etc... plus you may need to adjust various things to get the correct geometry. |
|
| Author: | lil-ute [ Fri Dec 01, 2006 2:05 pm ] |
| Post subject: | |
wooo hoooo im not the only person with stupid questions |
|
| Author: | Mike_Byron [ Fri Dec 01, 2006 2:21 pm ] |
| Post subject: | |
Steady on - steady on No such thing as stupid questions - all questions are valid although I have seen stupid answers at times although not necessarily off the Ausmini group. |
|
| Author: | Oscar [ Fri Dec 01, 2006 2:39 pm ] |
| Post subject: | |
Have a squiz at this - heaps of info and calculators as well. http://www.carbibles.com/tyre_bible.html |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|