www.minispares.com
search rimflow
I run them in Barney, the wife's car- because they got sent to me by mistake!!
I think on a road car their benefits are overstated, the special groove on the head of inlet valve carbons up.
| ausmini https://www.ausmini.com/forums/ |
|
| RimFlow valves.....where do i get them https://www.ausmini.com/forums/viewtopic.php?f=2&t=26918 |
Page 1 of 1 |
| Author: | volkmini [ Thu Jan 18, 2007 7:35 pm ] |
| Post subject: | RimFlow valves.....where do i get them |
hi, i'm woundering where it's possible to get a set of rimflow valves for a 1275 head. what would be the expected price for a set of valves exhaust or intake. thanks |
|
| Author: | drmini in aust [ Thu Jan 18, 2007 7:40 pm ] |
| Post subject: | |
www.minispares.com search rimflow
I run them in Barney, the wife's car- because they got sent to me by mistake!!
I think on a road car their benefits are overstated, the special groove on the head of inlet valve carbons up.
|
|
| Author: | volkmini [ Thu Jan 18, 2007 7:44 pm ] |
| Post subject: | |
but, would they be better than the stock one's |
|
| Author: | drmini in aust [ Thu Jan 18, 2007 8:02 pm ] |
| Post subject: | |
volkmini wrote: but, would they be better than the stock one's
If they were , racers would be running them. And no, most are not. They are heavier, and more expensive too. Stock `AE' brand valves from Karcraft etc are fine, even for racing use. Just back cut the inlet valve heads as per Vizard's book. 21/4N S/S race valves are OK too but need bronze guides or K-liners for use with unleaded fuel. I run these valves in my 1360.
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|