ausmini
https://www.ausmini.com/forums/

How to measure carby size?
https://www.ausmini.com/forums/viewtopic.php?f=2&t=27929		 Page 1 of 1
Author:  Moriarty [ Sun Feb 11, 2007 11:31 am ]
Post subject:  How to measure carby size?
Hey hey,

How do you measure carby size? We have one here that we pulled off Grace (my 68 Deluxe), the needle and seat are sticking but we've cleaned it up a bit.

Suspect the nylon ring in the seat is perished, so it will need to be replaced.

How do I work out what size the carburettor is in order to buy the right parts? Is it the internal diameter where the butterfly is located?
Author:  sports850 [ Sun Feb 11, 2007 11:35 am ]
Post subject: 
Yes , also , as an easy way of looking at it -

1 1/4 has 2 vertically opposed stud holes on the manifold side

1 1/2 has 2 diagonally opposed stud holes on the manifold side

1 3/4 has 4 square patterned stud holes on the manifold side
Author:  Moriarty [ Sun Feb 11, 2007 11:44 am ]
Post subject: 
Cheers Sports - looks like 1 1/4.

Are we on the right track re the needle / seat and replacing...?
Author:  sports850 [ Sun Feb 11, 2007 11:49 am ]
Post subject: 
Considerring the length of time it sat I'd say it'd be worth replacing anyway , you'll probably find a few more things like that too as you go . Just keep plodding along and sorting it out as it comes .
Author:  9YaTaH [ Sun Feb 11, 2007 11:50 am ]
Post subject:  32 Pistol...
Confirmed here too! I saw a 32mm carby on Grace :D I have plenty of carby bits and pieces ifn ya need em.... :D
Author:  Namibian CAMEL [ Mon Feb 12, 2007 8:38 pm ]
Post subject: 
There is a small town/area in Tassie called Moriarty.

Im pretty sure there is a school there.
Author:  9YaTaH [ Tue Feb 13, 2007 4:38 pm ]
Post subject:  Count Moriarty
I think Leigh's name is more about this stuff 8)

http://www.thegoonshow.net/characters.asp
Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/