| ausmini https://www.ausmini.com/forums/ |
|
| Link Automotive Extractors https://www.ausmini.com/forums/viewtopic.php?f=2&t=2859 |
Page 1 of 1 |
| Author: | 1380 yellow devil [ Mon Nov 15, 2004 11:40 am ] |
| Post subject: | Link Automotive Extractors |
Has anyone bought or are using the extractors from link auto http://www.linkautomotive.com.au/5.html These are the ones I am looking ot for my 1380 any thoughts would be great. |
|
| Author: | drmini in aust [ Mon Nov 15, 2004 1:26 pm ] |
| Post subject: | Re: Link Automotive Extractors |
1380 yellow devil wrote: Has anyone bought or are using the extractors from link auto
http://www.linkautomotive.com.au/5.html These are the ones I am looking ot for my 1380 any thoughts would be great. I run Maniflow LCB on my 1310 but those look good. What do they cost? |
|
| Author: | 1380 yellow devil [ Mon Nov 15, 2004 1:46 pm ] |
| Post subject: | |
I think round $350 they look nice may have to get a set and try. |
|
| Author: | 1380 yellow devil [ Tue Nov 16, 2004 5:06 pm ] |
| Post subject: | |
I will be ordering a set of these in 2 weeks as they have none in stock and then fit them and let you all know what I think of them then. They cost on a confirmed price of $352 of $552 HPC coated. |
|
| Author: | sweep77 [ Tue Nov 16, 2004 6:37 pm ] |
| Post subject: | |
i don't know how good they are but they look terrific! I've seen them in person and very schmick. |
|
| Author: | justminis [ Tue Nov 16, 2004 9:11 pm ] |
| Post subject: | |
I've run a set on my sprint mini for over 5 years, had them HPC'ed. A few of the Group N guys in Brisbane also run them. I'm happy with mine. They are a very tight fit against the firewall, and to help with clearance/head removal/etc I use cap screws instead of manifold studs. Steve |
|
| Author: | Rupert [ Wed Nov 17, 2004 7:51 am ] |
| Post subject: | |
I've had my ceramic coated ones for about the same time as Steve. No problems but remember they only work with a Weber, not SUs |
|
| Author: | 1380 yellow devil [ Wed Nov 17, 2004 12:42 pm ] |
| Post subject: | |
I rang them yesterday anf they said yes they will fit with a MG Metro Alloy 1.75 Manifold and all the has to be done is a small amout of the manifold has to be ground away to make a bit of clearence. |
|
| Author: | Rupert [ Wed Nov 17, 2004 1:20 pm ] |
| Post subject: | |
Maybe they need to update their website "Designed - in the heyday of the Mini Cooper 'S' - by Ron Brownrigg. Intended for maximum power, hence these extractors can only be fitted when a Weber type inlet manifold is used, or in conjunction with our Supercharger kit." |
|
| Author: | 1380 yellow devil [ Thu Nov 18, 2004 12:51 pm ] |
| Post subject: | |
These had only just been fitted about a week ago so give them time to change it. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|