ausmini
https://www.ausmini.com/forums/

sender unit on the sump
https://www.ausmini.com/forums/viewtopic.php?f=2&t=28616		 Page 1 of 1
Author:  peter1 [ Tue Feb 27, 2007 9:39 pm ]
Post subject:  sender unit on the sump
Howdy - Pulled the engine out tonight to give it a clean, repaint, replace gaskets and seals etc and tidy the engine bay up (while I'm waiting for the head to come back) and noticed I have some sort of sender unit on the sump with unconnected wires coming from it. The unit is sort of in the right hand upper corner on the sump as you look at the front of the motor. Could this have been an oil temp sender? Is it standard? There's no extra gauge in the car. Sorry no pics, doing the work at a mate's place and didn't have the camera.
Peter :)
Author:  ss wanab [ Tue Feb 27, 2007 9:41 pm ]
Post subject: 
might be a reversing light sensor :wink:
Author:  willy [ Tue Feb 27, 2007 9:42 pm ]
Post subject: 
It is for your reverse lights.
Author:  gafmo [ Tue Feb 27, 2007 9:42 pm ]
Post subject: 
Its for Reverse Lights Switch :wink:
Author:  peter1 [ Tue Feb 27, 2007 9:49 pm ]
Post subject: 
It's unanimous then - thanks guys! 8)
Peter. :)
Author:  gafmo [ Tue Feb 27, 2007 9:56 pm ]
Post subject: 
all withinn a minute of each other :lol:
Author:  ss wanab [ Tue Feb 27, 2007 10:13 pm ]
Post subject: 
i was first in 8)

had one on the motor i pulled out last :wink:
Author:  DOZ [ Tue Feb 27, 2007 10:14 pm ]
Post subject: 
Its a switch whose contacts close when the reverse gear is selected in the gearbox. Occasionally it is used to illuminate the amber lights at the rear of the car. :P :P :P

DOZ
Author:  willy [ Tue Feb 27, 2007 10:19 pm ]
Post subject: 
Ah there's always one in every thread :lol: :lol:
Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/