ausmini https://www.ausmini.com/forums/ |
|
Drive shaft, CV removal? https://www.ausmini.com/forums/viewtopic.php?f=2&t=29383 |
Page 1 of 1 |
Author: | Panthersteve [ Mon Mar 19, 2007 6:43 pm ] |
Post subject: | Drive shaft, CV removal? |
Hi I'm sure this would have been asked and answered before so sorry in advance. I am fitting discs to my "K" and have now removed the swivel hub and drive shaft as one item. My question is how do I seperate the driveshaft and the CV joint? Cheers Steve |
Author: | Mick [ Mon Mar 19, 2007 6:52 pm ] |
Post subject: | |
Holding the whole lot up by the drive shaft. Sustained tapping (read: bashing) on the outer of the CV with a soft hammer will pop the drive shaft out of the CV. It's held in by a detent spring. Don't do this over your bare feet and have a soft spot for the hub and CV to fall onto, like a pile of rags, or a wooden bench top. Maybe just hold it off the ground only a short distance. |
Page 1 of 1 | All times are UTC + 10 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |