I think they are 5/16? maybe not.. they are a wierd nut - no one has the 'correct' ones as the thread size is different to the nut.
Alot of the stuff you can buy these days uses metric hex bar with imperial thread which is
| ausmini https://www.ausmini.com/forums/ |
|
| Tie bar nyloc nut https://www.ausmini.com/forums/viewtopic.php?f=2&t=30003 |
Page 1 of 1 |
| Author: | GT [ Tue Apr 03, 2007 10:19 am ] |
| Post subject: | Tie bar nyloc nut |
Does anyone know what the thread size is for the nyloc Tie Bar nut? I want to grab 2 before the weekend, and I'm hoping somewhere local (like a hardware store) has some. |
|
| Author: | Mini Mad [ Tue Apr 03, 2007 10:56 am ] |
| Post subject: | |
I think they are 5/16? maybe not.. they are a wierd nut - no one has the 'correct' ones as the thread size is different to the nut. Alot of the stuff you can buy these days uses metric hex bar with imperial thread which is
|
|
| Author: | Blokeinamoke [ Tue Apr 03, 2007 12:04 pm ] |
| Post subject: | Re: Tie bar nyloc nut |
GT wrote: Does anyone know what the thread size is for the nyloc Tie Bar nut?
I want to grab 2 before the weekend, and I'm hoping somewhere local (like a hardware store) has some. I spent ages trying to find some - I ended up putting on new tie rods |
|
| Author: | Anto [ Tue Apr 03, 2007 12:12 pm ] |
| Post subject: | |
I thought they were something odd like 7/16 UNF, not too sure? |
|
| Author: | gafmo [ Tue Apr 03, 2007 12:18 pm ] |
| Post subject: | |
Try Lee's Bros 6 Dunlop Street North Parra 9890 1555 |
|
| Author: | Harley [ Tue Apr 03, 2007 1:01 pm ] |
| Post subject: | |
It is 7/16 UNF nyloc. It's the same size as the four on the rear subframe that hold the rubber mounts/bushes. The nuts on the ball joints are 7/16 too, though not nylocs. 
|
|
| Author: | GT [ Tue Apr 03, 2007 1:44 pm ] |
| Post subject: | |
helpfull...thankyou! |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|