| ausmini https://www.ausmini.com/forums/ |
|
| thermostat housing https://www.ausmini.com/forums/viewtopic.php?f=2&t=31189 |
Page 1 of 1 |
| Author: | Roundie [ Fri Apr 27, 2007 10:24 pm ] |
| Post subject: | thermostat housing |
does a thermostat housing of an 850 fit a 1275 ? |
|
| Author: | Hanra [ Fri Apr 27, 2007 10:28 pm ] |
| Post subject: | |
I would think not. |
|
| Author: | drmini in aust [ Fri Apr 27, 2007 10:29 pm ] |
| Post subject: | |
If car is a roundnose or early Clubby it will fit, the bolt pattern and pipe angle is the same. But original 850 one was shorter on top, make sure the thermostat fits in (but I think it will). On late Clubby radiator with top hose going back to near radiator neck, no, it won't. Easiest solution then is get another radiator. 
|
|
| Author: | Roundie [ Fri Apr 27, 2007 10:30 pm ] |
| Post subject: | |
no its a front facing housing |
|
| Author: | drmini in aust [ Fri Apr 27, 2007 10:33 pm ] |
| Post subject: | |
OK then. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|