ausmini
https://www.ausmini.com/forums/

Official Sydney MRC Dyno Day EXCUSES thread
https://www.ausmini.com/forums/viewtopic.php?f=2&t=31400		 Page 1 of 2
Author:  Lillee [ Fri May 04, 2007 4:09 pm ]
Post subject:  Official Sydney MRC Dyno Day EXCUSES thread
I thought I'd start early and be the one who starts the thread :lol: :lol: :lol: Post your excuses here :P

Should be a great day tomorrow guys! Big turn out! Cya there!!!
Author:  pristic [ Fri May 04, 2007 4:11 pm ]
Post subject: 
I know one I know one...

My choke cable must have been out!!!
Wait, now someone already used that... hmmm, Chong do you remember who said that at MDU?

Geez I cant remember but its on the tip of my tongue. ;)

Peter.
Author:  Lillee [ Fri May 04, 2007 4:12 pm ]
Post subject: 
:roll:

My excuse is my windows were down and I had a boot full of Mini T Shirts! :lol:

I bet there are alot of busy people working on their minis tonight! :lol:
Author:  slinkey inc [ Fri May 04, 2007 4:36 pm ]
Post subject: 
Err, can't make it, my car is 150hp, trust me but you see I live in Adelaide. :roll:


Hp rating of 150hp is by no means accurate and not to be taken seriously, however I do live in Adelaide.
Author:  drmini in aust [ Fri May 04, 2007 4:54 pm ]
Post subject: 
Mine was running too lean last time (got 75.4HP), this time I'll say it was too rich... :lol:
Author:  aaron [ Fri May 04, 2007 5:22 pm ]
Post subject: 
mine will be too heavy as it's van and it's got a full load of petrol. It'll be just weighed down to much :roll: :lol: :lol: :lol:

Cheers
Aaron
Author:  Hanra [ Fri May 04, 2007 6:58 pm ]
Post subject: 
I thought my mini was 4WD, and they use a 2WD dyno, so im not gunna bring it along...
Author:  drmini in aust [ Fri May 04, 2007 7:14 pm ]
Post subject: 
Lillee wrote:
:roll:


I bet there are alot of busy people working on their minis tonight! :lol:

Josh is up to his armpits in a couple as I write... :lol:
Author:  DOZ [ Fri May 04, 2007 7:24 pm ]
Post subject: 
More statement of fact than excuse - I haven't started the car since MDU

Daniel
Author:  gafmo [ Fri May 04, 2007 7:39 pm ]
Post subject: 
nope I'm not working on Morris and my hands are clean :wink:

My Excuse will be that the amount of Oil Morris will drop on the rollers..the wheels will spin to uch
Author:  LS1380 [ Fri May 04, 2007 8:04 pm ]
Post subject: 
I need a couple of jerry cans for the drive over!!
Author:  Mike_Byron [ Fri May 04, 2007 8:39 pm ]
Post subject: 
Quote:
Josh is up to his armpits in a couple as I write... Laughing


Ummm, let me read that again and again as I make sense of it - Emmaline - have you read and approved this ?????
Author:  drmini in aust [ Fri May 04, 2007 8:43 pm ]
Post subject: 
Mike_Byron wrote:
Quote:
Josh is up to his armpits in a couple as I write... Laughing


Ummm, let me read that again and again as I make sense of it - Emmaline - have you read and approved this ?????
Mike,

interpose the words...`of Minis'... :lol:
Author:  tinymorris1969 [ Fri May 04, 2007 9:29 pm ]
Post subject: 
my mini splatters and coughs and i can only pull 20kws :(
Author:  GT [ Fri May 04, 2007 11:22 pm ]
Post subject: 
Mine might be down on power on the dyno, as my handbrake tends to get stuck on. :wink:

See ewe's there. :D
Page 1 of 2 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/