| ausmini https://www.ausmini.com/forums/ |
|
| ID Mark 2 Cooper S Gearbox https://www.ausmini.com/forums/viewtopic.php?f=2&t=3151 |
Page 1 of 1 |
| Author: | Gezo [ Tue Nov 30, 2004 10:06 am ] |
| Post subject: | ID Mark 2 Cooper S Gearbox |
Hi, Does anybody know what to look at when identifying a geniune Mark 2 Cooper S gearbox. There is the 22G1128 cast number what else is there to look for. Thanks |
|
| Author: | gafmo [ Tue Nov 30, 2004 10:09 am ] |
| Post subject: | |
I can tell you its a 4 sycro remote Box Mines going onto my Mk2 Block |
|
| Author: | 1380 yellow devil [ Tue Nov 30, 2004 12:07 pm ] |
| Post subject: | |
do not know no one asked me that before |
|
| Author: | miniron [ Tue Nov 30, 2004 12:53 pm ] |
| Post subject: | |
3.44:1 diff ratio, Diff output flanges to suit Hardy Spicer needle roller inner unis, 1st motion shaft and laygear are different, all other gear box parts are the same as a non S box including the common 4 synchro case. If it's a genuine Mk2 S case then the original engine number 9FXEY etc should be stamped in the area below the starter motor on a raised boss on the front of the case. Regards RonR |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|