Yes, like any other car...
| ausmini https://www.ausmini.com/forums/ |
|
| early metro ball joints https://www.ausmini.com/forums/viewtopic.php?f=2&t=31834 |
Page 1 of 1 |
| Author: | mini-dunger [ Thu May 17, 2007 7:45 am ] |
| Post subject: | early metro ball joints |
Hi all Karcraft just told me they will not be getting any early metro ball joints until atleast late june early july. Does anyone know of anywhere I may be able to get these sooner. Thanks in advance Michael |
|
| Author: | minimetoy [ Thu May 17, 2007 8:45 am ] |
| Post subject: | |
MG Heritage at smithfield NSW. Dan |
|
| Author: | JC [ Thu May 17, 2007 2:01 pm ] |
| Post subject: | |
Epay.co.uk |
|
| Author: | miniboy1962 [ Thu May 17, 2007 4:31 pm ] |
| Post subject: | |
I got a quote from MG Heritage and it was $45 each... So... Is this what i need? It is so confusing - Austin, Rover, Metro, Turbo... http://cgi.ebay.co.uk/AUSTIN-METRO-UPPE ... dZViewItem |
|
| Author: | mini-dunger [ Thu May 17, 2007 9:21 pm ] |
| Post subject: | ball joints |
yes, you need before 84 ones |
|
| Author: | minimetoy [ Thu May 17, 2007 9:37 pm ] |
| Post subject: | |
Not sure if what you need? The difference in the two ball joints is the diameter of the taper. So if you are using mini suspension you should be able to use mini ball joints???? because the taper will fit into the upper arm and the lower arm. Dan |
|
| Author: | mini-dunger [ Thu May 17, 2007 9:47 pm ] |
| Post subject: | ball joints |
no they are totally different, metro ball joints have no shims and a more of a bolt type arrangement that screws into the uprights. early metro ones have a smaller taper which suits the mini control arms. the later metro ones have a thicker ball joint shaft with a different taper. |
|
| Author: | simon k [ Thu May 17, 2007 10:20 pm ] |
| Post subject: | Re: ball joints |
mini-dunger wrote: no they are totally different,
metro ball joints have no shims and a more of a bolt type arrangement that screws into the uprights. early metro ones have a smaller taper which suits the mini control arms. the later metro ones have a thicker ball joint shaft with a different taper. so they're throw away whe they're worn? |
|
| Author: | drmini in aust [ Thu May 17, 2007 10:26 pm ] |
| Post subject: | |
Yes, like any other car...
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|