5 degrees. I did my own.
Buy a straight pipe and bring it over.
| ausmini https://www.ausmini.com/forums/ |
|
| Dementions of Exhaust bend https://www.ausmini.com/forums/viewtopic.php?f=2&t=32337 |
Page 1 of 1 |
| Author: | gafmo [ Thu May 31, 2007 7:32 pm ] |
| Post subject: | Dementions of Exhaust bend |
Just got a Center exit muffler I know I can purchase a centre pipe from the likes of Karcraft but does anyone know what the dementions of the bend to go around a remote change so I can get a muffler shop to make one up for me |
|
| Author: | drmini in aust [ Thu May 31, 2007 7:44 pm ] |
| Post subject: | |
5 degrees. I did my own. Buy a straight pipe and bring it over.
|
|
| Author: | gafmo [ Thu May 31, 2007 7:48 pm ] |
| Post subject: | |
Okay cool...cheers Dr...May have to get it welded also..thiers only 1cm of pipe where its been cut off 
|
|
| Author: | drmini in aust [ Thu May 31, 2007 7:51 pm ] |
| Post subject: | |
No worries. 
|
|
| Author: | gafmo [ Thu May 31, 2007 8:01 pm ] |
| Post subject: | |
You got a pipe bender also 
what don't you have 
|
|
| Author: | Lillee [ Fri Jun 01, 2007 8:43 am ] |
| Post subject: | |
You have a centre exit and need bending? I have no bends and yes I have a remote... confused... |
|
| Author: | VicMini13 [ Fri Jun 01, 2007 9:42 am ] |
| Post subject: | Re: Dementions of Exhaust bend |
gafmo wrote: Just got a Center exit muffler
I know I can purchase a centre pipe from the likes of Karcraft but does anyone know what the dementions of the bend to go around a remote change so I can get a muffler shop to make one up for me If you're going to get an exhaust shop to bend the pipe, just drive up onto their hoist and let then do it all - at least then you have someone to get back to if it's not right. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|