| ausmini https://www.ausmini.com/forums/ |
|
| Oh , another one , mini/moke/cooper engine on ebay https://www.ausmini.com/forums/viewtopic.php?f=2&t=32398 |
Page 1 of 1 |
| Author: | sports850 [ Sat Jun 02, 2007 1:31 pm ] |
| Post subject: | Oh , another one , mini/moke/cooper engine on ebay |
I'm surprised they even mentioned moke as everyone else only ever uses cooper to describe mini bits ... http://cgi.ebay.com.au/MINI-MOKE-COOPER ... dZViewItem |
|
| Author: | gafmo [ Sat Jun 02, 2007 3:43 pm ] |
| Post subject: | |
Crank looks a little Rusty |
|
| Author: | supercharged 850 [ Sun Jun 03, 2007 5:36 pm ] |
| Post subject: | |
Suit rebuild? Suit recycling, i'd say.... Stripped 998's dont sell. Been there, tried that. |
|
| Author: | andbat [ Sun Jun 03, 2007 5:58 pm ] |
| Post subject: | |
if anyone has a spare beauty of a 998cc block lying around let me know though. |
|
| Author: | supercharged 850 [ Sun Jun 03, 2007 6:02 pm ] |
| Post subject: | |
I've got 5..... ranging from standard bore to +.060 .... and i'd bet i'm not the only one. |
|
| Author: | sports850 [ Sun Jun 03, 2007 6:07 pm ] |
| Post subject: | |
How good or bad does it have to be Andrew , might have one needing a rebuild but can't remember for certain . |
|
| Author: | andbat [ Mon Jun 04, 2007 8:19 pm ] |
| Post subject: | |
i wouldn't mind a great standard 998cc block, but if i have to bore it out it'd be okay to so long as i didn't have to bore it out to far. are you able to bore one out enough where you only have to change the rings and not the whole piston? or is it only whole piston bores allowed? i guess this should be moved to a series mods section |
|
| Author: | drmini in aust [ Mon Jun 04, 2007 9:08 pm ] |
| Post subject: | |
andbat wrote: i wouldn't mind a great standard 998cc block, but if i have to bore it out it'd be okay to so long as i didn't have to bore it out to far.
are you able to bore one out enough where you only have to change the rings and not the whole piston? or is it only whole piston bores allowed? i guess this should be moved to a series mods section Rings suit the piston size. If you rebore to next size you fit oversize pistons and rings. These are not much more than a set of rings alone. I got 1098 +.040" Hypatecs for $159, rings included. 998s would be similar. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|