just started removing the clubby front off my convertable today , took the strip off the sides and have started to drill spot welds out, what i would like to know is

recommended drill bit size in mm

have most people helped prize the panels apart around the welds or does it just come quite loose once all welds are drilled out

cheers Paul

_________________
with the fury of a Monkey Dishwasher aimed at your Purple

57 Morris minor
88 Rover Mini

As small as possible to break the spot weld (say about an 1/8th) and so that you can lever the panels gently apart.

There is a special drill bit you can get with a flat bottom.

_________________
"Show me the Mini!"

thanks for that

i have got my mate to order one (drill bit) through his paint and panel shop so i can get it a bit cheaper as they are a bit pricey

cheers Paul

_________________
with the fury of a Monkey Dishwasher aimed at your Purple

57 Morris minor
88 Rover Mini

You can buy a special spot weld drill for around $2o.

Doogie

_________________
I won Hay once, here's the pic to prove it..


Hay, it's not about the car, it's not about the venue, it's about the people that come here. Peter Dwyer, Mayor of Hay NSW.