Vtek16 wrote:
Does anyone know a good brake workshop
You'll find that more people will be able to help if you put your location in your profile (state, city, town , or suburb, etc)
| ausmini https://www.ausmini.com/forums/ |
|
| Brake Master Specs https://www.ausmini.com/forums/viewtopic.php?f=2&t=33107 |
Page 1 of 1 |
| Author: | Vtek16 [ Wed Jun 20, 2007 9:51 pm ] |
| Post subject: | Brake Master Specs |
Hi, Just wondering if anyone has - or knows where to get specs for the late model twin servo master cylinder i know ap lockheed made them but are no longer around Thx, Ash |
|
| Author: | Vtek16 [ Thu Jun 21, 2007 8:00 pm ] |
| Post subject: | |
Why are theese specs so hard to find, Im trying to see if i can fit a wrx master but i gota find out if its going to be possible. Does anyone know a good brake workshop Thx |
|
| Author: | KLAS [ Thu Jun 21, 2007 9:19 pm ] |
| Post subject: | |
all i can tell you is that it has a 0.81" bore if you mean the GMC242 |
|
| Author: | speedy [ Thu Jun 21, 2007 9:25 pm ] |
| Post subject: | |
Vtek16 wrote: Does anyone know a good brake workshop
You'll find that more people will be able to help if you put your location in your profile (state, city, town , or suburb, etc)
|
|
| Author: | Vtek16 [ Fri Jun 29, 2007 8:11 pm ] |
| Post subject: | |
Thanks Guys Iv dropped my spare master into a brake wholesaller and ill have to see how i go with matching up a similar spec unit but the pipe outlets on the opposite side |
|
| Author: | dove grey 64 [ Fri Jun 29, 2007 10:09 pm ] |
| Post subject: | |
ask brickworx, he wrecks late model rovers with the setup your after |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|