| ausmini https://www.ausmini.com/forums/ |
|
| Tail/brake lights https://www.ausmini.com/forums/viewtopic.php?f=2&t=33844 |
Page 1 of 1 |
| Author: | Wombat [ Sat Jul 14, 2007 11:48 am ] |
| Post subject: | Tail/brake lights |
Does anyone know the ratio of brighness level between the tail lights and brake lights? - I realise I could just go by the wattage but I'm sure I saw somewhere each is designated by a level of 'brighness' - also do indicators have a 'standard' brighness? |
|
| Author: | TK [ Sat Jul 14, 2007 4:46 pm ] |
| Post subject: | |
"level of 'brighness' - also do indicators have a 'standard' brighness" Dunno about the level of brighness of hand but maybe Queensland Transport could help with the official level of illumination. Check them out Dave. |
|
| Author: | MINImal effort [ Sat Jul 14, 2007 5:02 pm ] |
| Post subject: | |
Have recently been chasing up same sort of info regarding Reversing lights. Unfortunately watts to brightness is not possible as they are different scales of measurement. ( And the ADR regs quote lumens (?) not watts.... yet to see a bulb advertising other than watts ) However as a rule of thumb I got this info from a Bulb catalogue: Quote: Watts vs. Candle Power As a guide, the following comparisons can be
made between these 2 measurements of power or brightness: 2w = 3cp 6w = 6cp 10w = 15cp 16w = 21cp 25w = 32cp 35w = 50cp If you have a look at the Narva web sie they have a list of ADR compliant lights - and you could look up specs of appropriate fitting... http://www.narva.com.au/ADR_Listing_1.html |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|