ausmini
https://www.ausmini.com/forums/

subframe tower bolts thread type
https://www.ausmini.com/forums/viewtopic.php?f=2&t=33937		 Page 1 of 1
Author:  cool69 [ Tue Jul 17, 2007 8:23 am ]
Post subject:  subframe tower bolts thread type
Hi, Can some one please tell me what type of thread is used on the front subframe tower bolts, i have an old subframe and i want to clean up the threads with a tap and die
Author:  Wombat [ Tue Jul 17, 2007 10:13 am ]
Post subject: 
Early ones had ½" AF - later ones had metric thread
Author:  66S [ Tue Jul 17, 2007 10:45 am ]
Post subject: 
Wombat wrote:
Early ones had ½" AF - later ones had metric thread


Hi Cooper,
Wombat has tried to help but has given you a wrench size, not a thread size. I can't help either but recognized the mistake (and hopefully before you tried to buy a tap).
Early diameter was 5/16" but not sure if they were fine or coarse thread.

Regards
Al
Author:  Wombat [ Tue Jul 17, 2007 12:15 pm ]
Post subject: 
Sorry - I was thinking CONE thread size :oops:
Author:  Mick [ Tue Jul 17, 2007 12:22 pm ]
Post subject: 
UNF
Author:  cool69 [ Tue Jul 17, 2007 12:23 pm ]
Post subject: 
thanks:)
Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/