Noooooooooooooooooooooooooooooooooooooooooooooooooooooooo!
| ausmini https://www.ausmini.com/forums/ |
|
| help required, what have I broken ? https://www.ausmini.com/forums/viewtopic.php?f=2&t=34285 |
Page 1 of 1 |
| Author: | matt850 [ Sun Jul 29, 2007 10:25 am ] |
| Post subject: | help required, what have I broken ? |
Morris has picked up a nasty smoking habit. Blue smoke = oil I guess. He is also missing/starving when going round right hand bends. This is sounding very sinister to me ? Any thoughts. Something broken inside ??? |
|
| Author: | scotta_74 [ Sun Jul 29, 2007 10:56 am ] |
| Post subject: | |
Noooooooooooooooooooooooooooooooooooooooooooooooooooooooo!
|
|
| Author: | graham in aus [ Sun Jul 29, 2007 11:05 am ] |
| Post subject: | |
Does it have a servo? (Booster) How are the brakes?  
|
|
| Author: | matt850 [ Sun Jul 29, 2007 11:34 am ] |
| Post subject: | |
no servo. |
|
| Author: | graham in aus [ Sun Jul 29, 2007 11:50 am ] |
| Post subject: | |
Thought it might be brake fluid leaking into the servo and getting burned via the vacuum hose. I would take the top of the carby float bowl and clean it out, check float (any fluid in it?) and float height, and water in fuel / float bowl bottom? Check fuel pump output, measure flow rate into a jug? Also do normal checks on compression, points gap, plugs etc?
|
|
| Author: | tinymorris1969 [ Sun Jul 29, 2007 11:52 am ] |
| Post subject: | |
didnt u juz put a new cam in the engine matt? blue smoke sounds odd but the missing around corners sounds like not enough fuel... happen to me when i put the new carby on for a while till i realised that the old carby had been modified with a bigger needle and jet so compensate with the cam? possible problem.. when u say he blows blue smoke how often? |
|
| Author: | 9YaTaH [ Sun Jul 29, 2007 11:53 am ] |
| Post subject: | Something obvious... |
graham in aus wrote: Does it have a servo? (Booster) How are the brakes?
What Graham was saying was look for obvious things.....the vac line to boosted cars is a common one....a vacuum/breather line off, split or blocked is another possibility. You could also have two unrelated problems  check the fuel lines from the carbys right back to the tank(s)...I suppose you could also have a fuel pump thats on the way out...next 
|
|
| Author: | drmini in aust [ Sun Jul 29, 2007 11:55 am ] |
| Post subject: | |
When you swapped the heads did you scrape ALL the carbon off the pistons? If you did, it may be the cause of the oil smoke- the carbon on the edge of the piston crown can act as a seal against oil burning once motor has a few miles up. If so, it will come good once it carbons up a bit. It could also be the valve guides letting oil get sucked down if worn- I always put valve stem seals on the inlets now, even on old smallbore heads that never had proper ones originally. |
|
| Author: | 9YaTaH [ Sun Jul 29, 2007 12:04 pm ] |
| Post subject: | Head change... |
drmini in aust wrote: When you swapped the heads did you scrape ALL the carbon off the pistons? If you did, it may be the cause of the oil smoke- the carbon on the edge of the piston crown can act as a seal against oil burning once motor has a few miles up.
If so, it will come good once it carbons up a bit. It could also be the valve guides letting oil get sucked down if worn - I always put valve stem seals on the inlets now, even on old smallbore heads that never had proper ones originally. Always nice to have the full story...aye Doc
Maybe Ausmini should get a change of format so that all the problems with a particular car/engine are in the one place
|
|
| Author: | matt850 [ Sun Jul 29, 2007 1:58 pm ] |
| Post subject: | |
it has driven quite a lot of miles since the head change and started doing this today. thought it might have been internal and drastic to come on so suddenly. |
|
| Author: | gerg [ Sun Jul 29, 2007 2:48 pm ] |
| Post subject: | |
God dam!!, when will it end....  , i hope it's nothing too serious Matt.
|
|
| Author: | minivanman [ Sun Jul 29, 2007 5:00 pm ] |
| Post subject: | Re: Head change... |
9YaTaH wrote: Maybe Ausmini should get a change of format so that all the problems with a particular car/engine are in the one place
Then what would we talk about? |
|
| Author: | tinymorris1969 [ Sun Jul 29, 2007 5:30 pm ] |
| Post subject: | Re: Head change... |
minivanman wrote: 9YaTaH wrote: Maybe Ausmini should get a change of format so that all the problems with a particular car/engine are in the one place Then what would we talk about? I KNOW!!! spider pig..spider pig does whatever spider pig.. can he swing through a web..no he can't cause he's spider pig  sorry i juz watched the simpsons movie and still excited about it
|
|
| Author: | scotta_74 [ Sun Jul 29, 2007 7:30 pm ] |
| Post subject: | Re: Head change... |
tinymorris1969 wrote: minivanman wrote: 9YaTaH wrote: Maybe Ausmini should get a change of format so that all the problems with a particular car/engine are in the one place Then what would we talk about? I KNOW!!! spider pig..spider pig does whatever spider pig.. can he swing through a web..no he can't cause he's spider pig sorry i juz watched the simpsons movie and still excited about itRighhhhhhhhhhhhhhhhhhttttttttttttttttttttttttttt  Come here Tiny and let me slap you! 
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|