that fasten the piano hinge on the rear side windows?
i vaguely recall them being countersunk philips, but not sure of size, or if they are set screws or self tappers.....
and, i have no idea where i have put mine.
cheers
michael
| ausmini https://www.ausmini.com/forums/ |
|
| what size are the screws https://www.ausmini.com/forums/viewtopic.php?f=2&t=34731 |
Page 1 of 1 |
| Author: | mickmini [ Sun Aug 12, 2007 12:37 pm ] |
| Post subject: | what size are the screws |
that fasten the piano hinge on the rear side windows? i vaguely recall them being countersunk philips, but not sure of size, or if they are set screws or self tappers..... and, i have no idea where i have put mine.
cheers michael |
|
| Author: | Curly [ Sun Aug 12, 2007 12:58 pm ] |
| Post subject: | |
Chrome plated, Phillips Head counter sunk self tappers. 6 guage x 1/2" |
|
| Author: | mickmini [ Sun Aug 12, 2007 1:19 pm ] |
| Post subject: | |
cheers curly |
|
| Author: | drmini in aust [ Sun Aug 12, 2007 4:30 pm ] |
| Post subject: | |
Watch it there are 2 thread pitches in 6 gauge, #6x32 and #6x40. Not sure which these are.. best to find a sample and take it. |
|
| Author: | rampage101 [ Sun Aug 12, 2007 5:53 pm ] |
| Post subject: | |
Does it really matter which thread pitch? As its only going through the 1 layer of sheet steel no? |
|
| Author: | mini-dunger [ Sun Aug 12, 2007 6:00 pm ] |
| Post subject: | |
I had the same problem, I use a little bigger ones that mentioned above. I couldnt really get them to bite that much so I countersunk it a bit more and use some bigger SS ones. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|