ausmini
https://www.ausmini.com/forums/

3 clock dash face plate template
https://www.ausmini.com/forums/viewtopic.php?f=2&t=3504		 Page 1 of 1
Author:  ozmotorsport [ Fri Dec 17, 2004 3:32 pm ]
Post subject:  3 clock dash face plate template
Guys

ages ago on the other web forum someone posted a link to a web page that had a collection of templates for dash face plates anyone heard or know of it?

I'm wanting to make a face plate that runs from far left of dash to meet left hand side of three clock console. Two way to to it. 1) buts up agains three clock console. 2) Other ideas is to cut part of lastic clock cver away on left hand side so face plate slides in behind.

Can anyone help with a diagram, measurements or plans?
Author:  drmini in aust [ Fri Dec 17, 2004 3:41 pm ]
Post subject: 
Oz,
I think I have one of each type... I'll dig them out tomorrow and take some pics. :wink:
Author:  ozmotorsport [ Fri Dec 17, 2004 5:07 pm ]
Post subject: 
You da man

Hey kev, got some pix comming tomorrow of something interesting on the car. Did you ever get the feeling that car used to have a flip front?
Author:  drmini in aust [ Fri Dec 17, 2004 6:15 pm ]
Post subject: 
Nope, I rebuilt the motor & box, but I never pulled the motor out- Dean did. :wink:
Author:  1380 yellow devil [ Fri Dec 17, 2004 7:04 pm ]
Post subject: 
I would not mind to know where i can get a set of plans that include the 3 Gauges in it.

I mean the dash is th fulll way across left to right. I do have the Clubman top and bottom dash sections also.
Author:  J_A_M [ Fri Dec 17, 2004 8:40 pm ]
Post subject: 
Chris, I have EXACTLY what you are after. A trimmed dash fascia that butts up nicely to the original 3 clock binnacle. I am using it for a template in my own car. It has padded vinyl trimmed over it, but I am going to remove that and use the MDF again with new trim. :wink:

Gimme a day or so and I will measure it up for you.
Author:  ozmotorsport [ Fri Dec 17, 2004 10:09 pm ]
Post subject: 
Great, do me a favour and trace it onot a bit of MDF for me then I can just cut it out and fit it next week.


Thanks
Whooo hoo
Author:  J_A_M [ Fri Dec 17, 2004 10:14 pm ]
Post subject: 
would you like fries with that? :lol:

I'll see what I can do......
Author:  ozmotorsport [ Sat Dec 18, 2004 1:16 pm ]
Post subject: 
if it would be easier, just trace it onto a large peice of paper and mail it to me.
Author:  J_A_M [ Sat Dec 18, 2004 8:46 pm ]
Post subject: 
yea, that I can do. I might get my 2 year old son to help.... :lol: ...he loves drawing!
Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/