NO you rotate them a bit after liberally spraying WD40 up in there. They have a bayonet lug setup similar to a fuel cap.
| ausmini https://www.ausmini.com/forums/ |
|
| do i use a BFH https://www.ausmini.com/forums/viewtopic.php?f=2&t=35978 |
Page 1 of 1 |
| Author: | lil-ute [ Sat Sep 22, 2007 6:57 pm ] |
| Post subject: | do i use a BFH |
pulled apart four subframes so far got six to go (need room for my new toy)do i bash the living daylights out of the hydro units to get them out of there homes |
|
| Author: | drmini in aust [ Sat Sep 22, 2007 6:58 pm ] |
| Post subject: | |
NO you rotate them a bit after liberally spraying WD40 up in there. They have a bayonet lug setup similar to a fuel cap.
|
|
| Author: | lil-ute [ Sat Sep 22, 2007 7:00 pm ] |
| Post subject: | |
thank you dr & how do i know if they are stuffed |
|
| Author: | drmini in aust [ Sat Sep 22, 2007 7:25 pm ] |
| Post subject: | |
Well the usual place they can go is the hose where it fits onto the bag. But this can be fixed- see Todd Miller's site http://www.austinamericausa.com/ and scroll down to technical advice. Somebody on here fixed some recently, I'll look for the pics I saved.... I've never had one go, so never tested one. As an engineer I'd put an air hose onto it at 120psi whilst it's in the subby and pour water in there. If there's bubbles around it you have a problem.
<edit> here's the pics from a thread somewhere in ausmini.... 
Al, You can see the bayonet lugs I referred to, in 2nd pic. 
|
|
| Author: | lil-ute [ Sun Sep 23, 2007 7:23 am ] |
| Post subject: | |
so i need alot of wd40 and a few choice words shouldnt be a problem cheers allan |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|