Do the bolts which hold the flange plate to the rotor itself have the normal clockwise thread pattern? Changing rotors to newbies and the bolts r being un co-operative?
thanks, steve
| ausmini https://www.ausmini.com/forums/ |
|
| qu about cooper s discs https://www.ausmini.com/forums/viewtopic.php?f=2&t=36311 |
Page 1 of 1 |
| Author: | mooman10_0 [ Tue Oct 02, 2007 7:03 pm ] |
| Post subject: | qu about cooper s discs |
Do the bolts which hold the flange plate to the rotor itself have the normal clockwise thread pattern? Changing rotors to newbies and the bolts r being un co-operative?
thanks, steve |
|
| Author: | drmini in aust [ Tue Oct 02, 2007 7:16 pm ] |
| Post subject: | |
The 4 phillips head screws- yes they do. Use an impact driver... 
|
|
| Author: | mooman10_0 [ Tue Oct 02, 2007 7:23 pm ] |
| Post subject: | |
Tried on one side and it just chewed the head, and it was a good philips head piece, the metal just gave way, so will ahve to drill that one, hopefully the others come out better! |
|
| Author: | Mick [ Tue Oct 02, 2007 7:51 pm ] |
| Post subject: | |
When you go to get replacements from a bolt supplier, if you take out the rear drum screws, they are the same thread and countersunk head shape, just a little shorter. You could even get a the longer ones for the spacer drums and cut them down. |
|
| Author: | drmini in aust [ Tue Oct 02, 2007 7:52 pm ] |
| Post subject: | |
Or you could go buy some noice Allen head csk screws from a fastener place.
|
|
| Author: | simon k [ Tue Oct 02, 2007 8:40 pm ] |
| Post subject: | |
drmini in aust wrote: Or you could go buy some noice Allen head csk screws from a fastener place.
I second that... |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|