Can someone tell me what bore size master cylinders these are?
Cheers,
Simon
| ausmini https://www.ausmini.com/forums/ |
|
| What size master cylinders are these? https://www.ausmini.com/forums/viewtopic.php?f=2&t=36352 |
Page 1 of 1 |
| Author: | sgc [ Wed Oct 03, 2007 7:50 pm ] |
| Post subject: | What size master cylinders are these? |
Can someone tell me what bore size master cylinders these are?
Cheers, Simon |
|
| Author: | drmini in aust [ Wed Oct 03, 2007 8:08 pm ] |
| Post subject: | |
They could be either 0.70" (brake) or 0.75" (usual for clutch). Often the size is marked on the body, 1/2 way up. 
|
|
| Author: | sgc [ Wed Oct 03, 2007 8:17 pm ] |
| Post subject: | |
Poo. If I knew the size was marked, I would have checked before I left the car in Brisbane 
Well then.. I might not need a bigger one after all. Thanks Doc, a font of knowledge as usual 
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|