As makka said, pump until new stuff oozes out.
| ausmini https://www.ausmini.com/forums/ |
|
| mixing grease? https://www.ausmini.com/forums/viewtopic.php?f=2&t=3696 |
Page 1 of 1 |
| Author: | monrel [ Wed Dec 29, 2004 2:16 pm ] |
| Post subject: | mixing grease? |
im in the process of putting my rear radius arms back together, and i have bought some new grease. how important is it for me to flush out the old grease so that i can pump the new grease into the pivot bearing? can i just clean the outside of the shaft? then pump new grease through the nipple after putting it all back together? or do i have to get the old grease out of the INSIDE of the shaft too? |
|
| Author: | min13k [ Wed Dec 29, 2004 2:28 pm ] |
| Post subject: | |
if it is the same type of grease should be no biggy the important thing is to get it to ooze out makka hey btw do you have a redish roundy with silver stripe's |
|
| Author: | drmini in aust [ Wed Dec 29, 2004 2:29 pm ] |
| Post subject: | |
As makka said, pump until new stuff oozes out.
|
|
| Author: | monrel [ Wed Dec 29, 2004 4:29 pm ] |
| Post subject: | |
thanks guys!! will pump 'til new stuff oozes out! Quote: hey btw do you have a redish roundy with silver stripe's
no sorry makka, that ain't me. i've only got the one mini, and it aint roadworthy YET
|
|
| Author: | min13k [ Wed Dec 29, 2004 9:24 pm ] |
| Post subject: | |
ok cos i seen it today in a front yard out there as i went past makka |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|