ausmini
https://www.ausmini.com/forums/

Clutch issues, advice required
https://www.ausmini.com/forums/viewtopic.php?f=2&t=37202		 Page 1 of 1
Author:  lurker [ Mon Oct 29, 2007 12:10 pm ]
Post subject:  Clutch issues, advice required
OK so here is what I know. Over the last couple of weeks when the car has been running a while or driving in heavy traffic I notice when I let my foot off the clutch it grabs, then Dad said he drove it and it was rather hard to get into gear.

On Saturday I got into it, put my foot on the clutch and it went straight to the floor, no resistance, I didn't think much of this, and tried to put it into gear, nothing, wouldn't budge at all.

After Dad bleeding the clutch, checking slave and master cylinders, Diagnois Clutch is gone.

You guys reckon this sounds about right? And has anyone put a clutch in a late model Rover Mini? What costs am I looking at :?:

PS- I'm really over Mini's too, sick of things breaking on them everytime I take the bloody things out. Thinking I might even sell the Lurekr Mini I've got, now I have a company car to get to and from work.
Author:  Spaceboy [ Mon Oct 29, 2007 12:14 pm ]
Post subject: 
i dont know alot about clutches but i've had more than a few clutch issues :(

it shouldnt be too hard/expensive to fix it though, i've had to pay to have my clutch fixed about 3 times.
Author:  TheMiniMan [ Mon Oct 29, 2007 1:49 pm ]
Post subject: 
It`s probably just the clutch arm breaking/cracking the little ball on the lower end of it

it`s easy enough to check, just pull the arm off & look

:-)
Author:  Mike_Byron [ Mon Oct 29, 2007 4:17 pm ]
Post subject: 
TheMiniMan wrote:
It`s probably just the clutch arm breaking/cracking the little ball on the lower end of it

it`s easy enough to check, just pull the arm off & look

:-)

Matt
Even on a verto clutch ????
It is a Rover. I am asking a question not being a smart alec (in this case

Mike :?
Author:  TheMiniMan [ Mon Oct 29, 2007 8:22 pm ]
Post subject: 
oops,,, thanks Mike,,, i didn`t look to see it was a late one

Ok,,, id be checking the Hydraulics first if i were you, sounds more like the master cyl has shat itself the more i read the question & decription of what it`s doing,,, (or rather what it`s not doing) :-)
Author:  Mini Mad [ Mon Oct 29, 2007 8:32 pm ]
Post subject: 
Yea definately sounds hydraulic related.

Dont forget the slave too :)
Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/