It takes two seconds to pop the top ball joints if you have pot joints...
Make sure the rodchange is in reverse - makes it easier to line the pin up
| ausmini https://www.ausmini.com/forums/ |
|
| drive shaft bitz... lol https://www.ausmini.com/forums/viewtopic.php?f=2&t=37508 |
Page 1 of 1 |
| Author: | dbr11k [ Wed Nov 07, 2007 10:13 pm ] |
| Post subject: | drive shaft bitz... lol |
um is there a thread on how too get your engine out lol i assume there would be but cant find it... maybe im not lookin hard enuff but i wanna know how to get the engine out of my 75 clubman.. it has drums. ive got every thing except the drive shaft and the gear rod change bit.. (i just need to punch it out i kno) is it possible(coz im lazy) too just undo the bolts on the casing and sort of lift the engin a bit and the will pop out?? |
|
| Author: | Mini Mad [ Thu Nov 08, 2007 9:04 am ] |
| Post subject: | |
It takes two seconds to pop the top ball joints if you have pot joints... Make sure the rodchange is in reverse - makes it easier to line the pin up
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|