this should go in the how to section, come on mods do it i dare you
| ausmini https://www.ausmini.com/forums/ |
|
| Adjusting Hi - Lo's https://www.ausmini.com/forums/viewtopic.php?f=2&t=38380 |
Page 1 of 1 |
| Author: | Davo111 [ Mon Dec 03, 2007 11:18 am ] |
| Post subject: | Adjusting Hi - Lo's |
OK, don't all laugh together I got Koni Hi. Lo's fitted, so i can play with my height. Forgot to get Steve to show me how to adjust them. So could you please explain, with Pics if possible, how to adjust the height. Davo111............... |
|
| Author: | mikkis37 [ Mon Dec 03, 2007 11:23 am ] |
| Post subject: | |
Just learnt how to do this recently. 1:- Jack up car! 2:- Remove Wheel for easy access 3:- undo locknut 4:- Mark one face of the nut so you know where you started 5:- Turn one full rotation at a time (or in increments) 6:- Do up locknut 7:- Change sides of the car and go from step one again. 8:- Go for a drive to allow it to settle a bit. 9:- Check ride height again 10:- Hopefully all done! |
|
| Author: | lil-ute [ Mon Dec 03, 2007 11:25 am ] |
| Post subject: | |
this should go in the how to section, come on mods do it i dare you
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|