| ausmini https://www.ausmini.com/forums/ |
|
| 850 - Sensor on the sump? https://www.ausmini.com/forums/viewtopic.php?f=2&t=38790 |
Page 1 of 1 |
| Author: | meehal [ Sun Dec 16, 2007 8:59 pm ] |
| Post subject: | 850 - Sensor on the sump? |
I was under the mini today and noticed a sensor on the front right coming from the sump, its not connected to anything but it has the two connectors for something? Any ideas? Electrical temp sensor? guessing.... Cheers, meehal. |
|
| Author: | 64cooper [ Sun Dec 16, 2007 9:01 pm ] |
| Post subject: | |
reversing lights |
|
| Author: | Wombat [ Sun Dec 16, 2007 9:06 pm ] |
| Post subject: | |
What he said^^^ - power supply in - lead out to reversing light When reverse is selected the power is supplied to the globe which has the other side earthed. + _____________/ ________--globe--______ _ earth |
|
| Author: | meehal [ Sun Dec 16, 2007 9:14 pm ] |
| Post subject: | |
ha thats interesting. i the lights with reverse just brake and indicate. thanks for that very helpful. |
|
| Author: | Wombat [ Mon Dec 17, 2007 7:53 am ] |
| Post subject: | |
You can wire up your indicators to act reversing lights. You need 3 diodes (4 if you want to use both indicators - separate supply to each side - don't loop a wire from one globe to the other or both sides will flash) (1N400*) will do - anything over 1N4001 is overkill but will do the job) wire one into each supply lead to the globe + ---->|---- globe---earth |
|
| Author: | Timbo [ Mon Dec 17, 2007 8:20 am ] |
| Post subject: | |
Later cars used dual filament globes in the indicators. On filament for flash the other for reveres. It gives you a slightly pale amber reverse light but better than nothing. Tim |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|