| ausmini https://www.ausmini.com/forums/ |
|
| re: new floor pans https://www.ausmini.com/forums/viewtopic.php?f=2&t=38967 |
Page 1 of 1 |
| Author: | andywado [ Sat Dec 22, 2007 12:08 pm ] |
| Post subject: | re: new floor pans |
Will a LHS front floor pan for a 77 clubby fit a 70 K? |
|
| Author: | drmini in aust [ Sat Dec 22, 2007 12:11 pm ] |
| Post subject: | |
yes it's the exact same floor, if we are talking Oz cars. |
|
| Author: | andywado [ Sat Dec 22, 2007 12:22 pm ] |
| Post subject: | |
Thanks Doc, I think they are both OZ cars. |
|
| Author: | Bubbacluby [ Sat Dec 22, 2007 5:03 pm ] |
| Post subject: | |
yeah it will fit but they are slightly differnt shape. the 77cluby doesnt have the risen up bit in the pans forthe hydro lines. but will fit Brenton |
|
| Author: | Anto [ Sat Dec 22, 2007 5:48 pm ] |
| Post subject: | |
I'm pretty sure the 77 clubby will still have the channels for the hydro lines as they still ran the brake and fuel lines through them on the late cars. The difference will be around the gearshift hole as it was higher to suit the rod change gearbox, but this shouldn't be a problem for your purpose. |
|
| Author: | drmini in aust [ Sat Dec 22, 2007 6:59 pm ] |
| Post subject: | |
Anto wrote: I'm pretty sure the 77 clubby will still have the channels for the hydro lines as they still ran the brake and fuel lines through them on the late cars. The difference will be around the gearshift hole as it was higher to suit the rod change gearbox, but this shouldn't be a problem for your purpose.
The late Clubby floors do have the hydro pressings, are practically the same except the bit around the 2 holes for the cotton reel shifter mounts. We never got the square tunnels like UK rodchange cars. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|