I shorten mine no problems, Then I got pinged at rego and had to replace it with an original one.
The guy was just being a twat!!!!
| ausmini https://www.ausmini.com/forums/ |
|
| how short are your sticks? https://www.ausmini.com/forums/viewtopic.php?f=2&t=39167 |
Page 1 of 1 |
| Author: | mini-dunger [ Wed Feb 13, 2008 6:05 pm ] |
| Post subject: | how short are your sticks? |
Hi all I have noticed that the gear lever on my rod change box is not tappered so I am assuming it would be ok to shorten it a little if I wanted to. Would it be a good idea? Ideas? thanks (its good to be back) |
|
| Author: | the bean [ Wed Feb 13, 2008 6:09 pm ] |
| Post subject: | |
26cm |
|
| Author: | club77 [ Wed Feb 13, 2008 6:47 pm ] |
| Post subject: | |
I shorten mine no problems, Then I got pinged at rego and had to replace it with an original one.
The guy was just being a twat!!!! |
|
| Author: | spraycanmansam [ Wed Feb 13, 2008 7:44 pm ] |
| Post subject: | |
I cut my gearstick down to about a third of normal length, looked cool but wasn't to good to change gears with. Much later I bought an original one and it was so much better... |
|
| Author: | Kennomini [ Wed Feb 13, 2008 7:53 pm ] |
| Post subject: | |
one day mine broke off where the rubber and cup join together so it was about an inch and a half long, changing gears is slower but twice as fun  
|
|
| Author: | doogie [ Wed Feb 13, 2008 8:44 pm ] |
| Post subject: | |
Factory size is the only size to have!!! Doogie |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|