That's a new one for me. I needed a tyre placard, which the place around the corner from your house supplied along with the engineer *hint* *hint*
| ausmini https://www.ausmini.com/forums/ |
|
| Engineer - Specification Sticker/Placard. Help! https://www.ausmini.com/forums/viewtopic.php?f=2&t=39255 |
Page 1 of 1 |
| Author: | Maxi23 [ Fri Feb 15, 2008 5:52 am ] |
| Post subject: | Engineer - Specification Sticker/Placard. Help! |
I'm getting the rover engineered, and the engineer wants a specification sticker in the engine bay for timing, gaps etc etc. What exactly needs to be on this sticker ? Can anyone scan one in and post up ? Can anyone tell me everything that needs to be on it for a Rover Mini ? Thanks! |
|
| Author: | speedy [ Fri Feb 15, 2008 6:06 am ] |
| Post subject: | |
That's a new one for me. I needed a tyre placard, which the place around the corner from your house supplied along with the engineer *hint* *hint*
|
|
| Author: | Maxi23 [ Fri Feb 15, 2008 7:12 am ] |
| Post subject: | |
Tyre placard was in the boot, lol. Chris at AMC is going to fix me up with a spec. sticker later this morning. He had some printed and has a few left over. Now to hope that the temporary plate in the exhaust does its job properly. I didn't know I'd need a spec. sticker. I'm sure he could have let it go through if he'd wanted to. He just didn't like the noisy exhaust. |
|
| Author: | brickworx [ Fri Feb 15, 2008 8:39 am ] |
| Post subject: | |
the sticker is still sitting on your old bonnet... somebody forgot to transfer it over to the new one |
|
| Author: | Anto [ Fri Feb 15, 2008 8:41 am ] |
| Post subject: | |
This sticker sounds like a tops idea. Personally I've never been able to make out the tuning specifications on the exhaust manifold without removing it from the car first. 
|
|
| Author: | Maxi23 [ Fri Feb 15, 2008 11:11 am ] |
| Post subject: | |
It's all engineered 
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|